Step 1: Place Ladder support along gutter at desired location. Use a pencil to trace inside diameter of both screw holes. Set the support out of the way and drill or punch both holes making sure screws will pass through…
Blog Archives
Chimney Flashing Kit Instructions
Step 1: Shingle up to and across the base of the chimney to a point where the tar-line is within at least 4 inches. Cut shingles to fit around the chimney base. Note: the shingle rows must continue to line…
Posted in Chimney Flashing Kit
Pro Flash Instructions
Step 1: Align flashings around chimney base prior to installing and mark along tops (see dashed line). This will help you in piece by piece installation alignment. Next, extend bottom flashing past chimney sides 2 to 3 inches. Notch top…
Posted in Pro Flash